PIC16F777-E/ML【PDF 57/231 页】IC PIC MCU FLASH 8KX14 44QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3873

53页 54页 55页 56页 [57页]58页 59页 60页 61页

2009 Microchip Technology Inc.

DS39636D-page 155

PIC18F2X1X/4X1X

REGISTER 16-2:

SSPCON1: MSSP CONTROL REGISTER 1 (SPI MODE)

R/W-0

WCOL

SSPOV

SSPEN

CKP

SSPM3

SSPM2

SSPM1

SSPM0

bit 7

bit 0

bit 7

WCOL: Write Collision Detect bit (Transmit mode only)

1 = The SSPBUF register is written while it is still transmitting the previous word

(must be cleared in software)

0 = No collision

bit 6

SSPOV: Receive Overflow Indicator bit

SPI Slave mode:

1 = A new byte is received while the SSPBUF register is still holding the previous data. In case

of overflow, the data in SSPSR is lost. Overflow can only occur in Slave mode. The user

must read the SSPBUF, even if only transmitting data, to avoid setting overflow (must be

cleared in software).

0 = No overflow

Note:

In Master mode, the overflow bit is not set since each new reception (and

transmission) is initiated by writing to the SSPBUF register.

bit 5

SSPEN: Synchronous Serial Port Enable bit

1 = Enables serial port and configures SCK, SDO, SDI and SS as serial port pins

0 = Disables serial port and configures these pins as I/O port pins

Note:

When enabled, these pins must be properly configured as input or output.

bit 4

CKP: Clock Polarity Select bit

1 = Idle state for clock is a high level

0 = Idle state for clock is a low level

bit 3-0 SSPM3:SSPM0: Synchronous Serial Port Mode Select bits

0101 = SPI Slave mode, clock = SCK pin, SS pin control disabled, SS can be used as I/O pin

0100 = SPI Slave mode, clock = SCK pin, SS pin control enabled

0011 = SPI Master mode, clock = TMR2 output/2

0010 = SPI Master mode, clock = FOSC/64

0001 = SPI Master mode, clock = FOSC/16

0000 = SPI Master mode, clock = FOSC/4

Note:

Bit combinations not specifically listed here are either reserved or implemented in

I2C mode only.

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

-n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式